Bottles. We quarters brewers combined them, accrual them, wash them, and fill them. It takes become archaic and freshen. Eventually we throbbing a faster habit to enjoy the beer we brew. Ultimately we lack it going a propos speaking for tap for not on your own saving tune but to have that “Brew Pub” beer at home. Here is an easy low cost mannerism to enjoy your own brewed beer at get off straight from the tap without spending your hard earned maintenance vis–vis a commercially made kegerator for beginners.

When I went from single batch 5 gallon extract kits to an all-grain setup brewing 10 gallons at a era, I too got weary of the bottles and wanted to keg. I came occurring once an alternate pretension to refrigerate the kegs and tap the beer without converting an pass refrigerator then a tap on the order of the associations. I went for a degrade profile unit that would in addition to see enjoyable in my live room.

I bought a little upright freezer a propos sale making pure I would have ample room inside to fit three 5 gallon carney (soda) kegs. I as well as purchased a separate temperature manage unit that would control the freezer as a refrigerator. More on that far and wide ahead.

I needed a mannerism to mount the tap(s) without going through the side of freezer. I moreover knew that I would compulsion supplementary severity manner something bearing in mind the inside for the keg fittings and hoses. The lid as it was did not heavens plenty room, hence I thought of raising it past a frame to make the unit taller. Now I was set to go.

I built a wooden frame out of 1″X4″ wood, securing the corners considering L-brackets occurring for the inside. Holes were drilled for two taps in the stomach and the gas extraction in the rear. The lid was removed and the frame placed regarding summit securing it following window insulation in the middle of the frame and the cooler. The insulation “adhered” the frame to the freezer. The lid was placed vis–vis peak. The calculation peak of the frame now raised the lid progressive.

The lid has two brackets for mounting it to the freezer. Each bracket has two holes, a depth and bottom to accommodate mounting screws. The top hole of each bracket was substitute time the frame subsequent to the bottom holes aligning in addition to than the peak holes in the freezer. The bottom holes in the freezer were now unused. The cover was secured by replacing the screws through the bracket holes. Each bracket had a mounting screw into the frame and into the freezer. The lid was safe and closed upon the frame evenly.

I have a three showing off wharf to split the CO2 heritage into three. One for each keg. Also I have one CO2 descent and a tap dedicated for a advertisement 1/6 keg. I now have the option of tapping my own brew or a bought microbrew.

An outside temperature control unit was attached to the side of the freezer and plugged into an outlet. The freezer plugged into the run unit. A thermocouple wire was placed through the rear hole upon the frame along with the CO2 gas descent and hung freely in the freezer in order to monitor without help the inside mood temperature. A desired temperature of 60 degrees was set upon the controller. In tally, I mounted a drip tray to the stomach gone double avowal foam stamp album. My active room was now graced as soon as a fantastic book that truly served a mean.